TypeS AC56794 Guide D'utilisation page 16

TROUBLESHOOTING:
Issue
Cannot jump start
LED light on the clamp box
keeps flashing
Flashlight does not turn on
The wireless charging
feature does not charge
my smartphone.
No wall adaptor
No LED indicator light
WARNING: This Jump Starter is only intended to jump start 12V cars, trucks, boats, or
motorcycles with an internal combustion engine and single lead-acid battery systems.
Do not use this device to jump start batteries outside of these four types of vehicles;
doing so may cause a fire or other serious injuries. Refer to the user manual for
additional safety information.
Have a comment or question? Email us at: info@typesauto.com
or visit us online at www.typesauto.com
A Horizon Brands Company
2975 Red Hill Ave., Ste. 100, Costa Mesa, CA 92626
1.866.294.9244 | info@typesauto.com
©2019 Type S. All rights reserved.
www.typesauto.com
Cause
Wrong clamp
connection
30-Second timer to
jump start has expired.
Low battery status
Protection circuit is
working
Low battery
The unit is charging
Your smartphone
cannot detect the
wireless charging pad
signal.
Your device does not
offer wireless charging
feature.
Charge via USB cable
Low battery
Power bank in off
mode
Remedy
Make sure to clamp the RED jumper cable to the
POSITIVE (+) post on the car battery. And BLACK
jumper cable to NEGATIVE (-) post or car interior.
Refer to Page 6 for details.
Jump starter timed out. Disconnect the cables from the
vehicle battery and reconnect.
Recharge the unit via USB cable until at least three
solid lights or 51% charge.
Refer to the status table on the indicator box or page
9 of the manual.
Recharge the unit via USB cable.
As a safety precaution, the flashlight light will not work
while the unit is charging. Please unplug the unit from
charging or wait until the unit finishes charging before
using the light.
Adjust your device on the wireless charging pad until
it starts charging.
If your smartphone has a case thicker than 0.3 mm,
you may need to remove the case in order to charge
your smartphone wirelessly.
The device you are charging must have the wireless
charging feature in order to use the wireless charging
pad.
Plug the USB cable into computer or any USB 2A
wall adaptor.
Refer to Power level indicator on page 4 of the
manual.
Press the power on/off.
16