Intended Use; Operation; Pc Software - Technoline TM 3098-RF Mode D'emploi

1. Intended use

The USB programming stick is used to program system
components such as wall thermostats or radio energy
saving controllers.
The USB stick does not have any controls and must be
used in conjunction with the associated PC software.
The device may only be operated indoors and must be
protected from the effects of damp and dust, as well as
solar or heat radiation.
Using the device for any purpose other than that described
in this operating manual does not fall within the scope of
intended use and shall invalidate any warranty. This also
applies to any conversion or modification work.
The device is intended for private use only.

2. Operation

Programming settings are made using the associated PC
software. For more information see Section 3, "PC
software".
The PC software uses the USB programming stick to send
the weekly programme, along with the date and time, to
devices that are ready to receive. For more information see
Section 4, "Radio transmission of programming settings".

3. PC software

The PC software for the USB programming stick can be
downloaded from www.technoline-berlin.de .
To start the download directly, type the following URL into
the address line of your browser:
www.technoline-berlin.de/software/heatingcontroller.zip
9