Radio Transmission Of Programming Settings - Technoline TM 3098-RF Mode D'emploi

Follow the on-screen instructions when downloading the PC
software.

4. Radio transmission of programming settings

So that the USB programming stick can send data to
system components
controllers or wall thermostats, these components must first
of all be set to teach-in mode.
• The USB programming stick must be plugged into the
PC's USB port.
• The PC software must be running on the PC and
programming must be complete.
• For transmission, the receiver (a wall thermostat, for
example) must be set to teach-in mode. For more
information on this, refer to the operating manual for the
relevant device.
• The USB programming stick can now send data to the
devices that are ready to receive. To start the
transmission process, activate the transmission function
in the PC software.
The USB programming stick does not remain permanently
taught–in on the devices to be programmed.
If the USB programming stick is being used to send
a weekly programme, all devices that are ready to
receive will receive the programme accordingly. An
unlimited number of receivers can be programmed.
When being put into operation for the first time, a
radio energy-saving controller can be switched to
teach-in mode immediately after data entry (please
see the corresponding operating manual for detailed
instructions). If a wireless signal is received from the USB
such as
10
radio energy-saving