Seat Adjustment And Adjustment Resistance - Deskshaper Pro BIS514 Mode D'emploi

4. SEAT ADJUSTMENT AND ADJUSTMENT RESISTANCE

STEP 1
Turn the control knob of the seat
counterclockwise to loosen it.
STEP 2
Pull the control knob of the seat to release
the seat.
STEP 3
When holding the pulled-out button, move
the seat cushion up or down to the correct
height. Release the button when the required
height is reached, and slowly move the seat
cushion down until the pin locks into place.
Check whether the seat is locked by pulling
the saddle up. If the seat is properly locked, it
will not move up or down.
STEP 4
Turn the control knob of the seat clockwise
to lock the control knob. Before use, fully
tighten the knob.
STEP 5 - Setting the standing position
There are numbers on the regulation of the
resistance, 1 to 8. Number 1 is the least
resistance and gure 8 is the highest
resistance.1. To increase the resistance, turn
the dial clockwise.
2. To decrease the resistance, turn the rotary
knob anticlockwise.
WARNING: The Deskshaper Pro should never be used with a separate
seat cushion. Pull the seat cushion for moving and / or using the Deskshaper
Pro upwards to ensure that it can not be removed.
- 9 -
EN