Promax SATHUNTER Mode D'emploi page 42

The top line of this screen is the same one for all functions of the equipment. Next
it will be explained the icons and messages that can appear depending on the situation.
At the top left corner it is shown the active function. There are three different
options: 1) DETECT, 2) IDENTIFY and 3) ADJUST.
When using the instrument, it may appear on the display some messages and
icons depending on the situation at that time. These are detailed below:
Message
"LOW BATTERY"
"VERY LOW BATTERY"
"LNB SHORT CIRCUIT"
"LNB OVER CURRENT"
"MANUAL POWER OFF"
"AUTO POWER OFF"
"SERVICE MODE"
"BATTERY MODE"
"UPDATE MODE"
"NETWORK NOT FOUND"
"SERVICES NOT FOUND"
"LNB NOT DETECTED"
"FULL BATTERY"
"MPEG-2 NOT DETECTED"
"LOADING NETWORK"
"LOADING SERVICES"
"HIGH TEMPERATURE"
Page 10
Description
-
The equipment will be switched off automatically.
The LNB can be shortcut.
The LNB has a high consumption.
The instrument has to be switched off by hand.
The instrument will switched off after five minutes of
inactivity.
-
-
-
-
-
Power level is below the minimum necessary to detect a
LNB (this value can be adjusted by software, usually
10 %).
-
It is not detecting the Transport Stream signal MPEG-2.
-
-
The running temperature is too high. The equipment must
be switched off for a while. If the problem persists, contact
with the technical support.
SATHUNTER USER'S MANUAL.
11/2009