Electrical Connection - Diamond MCX/7-PH Manuel De L'utilisateur

2.- POSITIONING
- To guarantee a good operation, place the machine in a completely plane place.
- Once placed the machine, activate the brakes of the front wheels to avoid any displacement.
- Disable the brakes every time the machine be moved. Only for SH-7000 Model.
-Don't move the machine when it´s working.

3.- ELECTRICAL CONNECTION

- AVOID ALL ACCIDENTAL GROUND STARTING. Before connecting the machine, verify that all the
elements of the machine are properly placed; otherwise it could cause a breakdown.
- CHECK THAT VOLTAGE OF ELECTRIC NETWORK is the same as the one shown in the identification sheet
of the machine.
- THE CONNETION INSTALLATION should possess differential protection and own thermal magneto,
also protected upstream.
- DO NOT START THE MACHINE IF THE ELECTRIC CABLE OR PLUG ARE DAMAGED.
- CONNECT THE PLUG to the electric network (230 V - 220 V - 110 V)
Note: Make sure that the ground connection is propely done and according with the valid standards.
4.- ON AND OFF
• Check that all the elements of the machine are in good position and that the machine's plug is
connected to the electric network of (230 V - 220 V - 110 V).
• The switch button is located in the right side of the machine; to switch it on press the button in a way
that the circle is in the area that stands out. (FIG. 1)
• To stop the machine, press the switch in a way that the line is in the area that stands out. (FIG. 1)
• To stop the machine push the button. ( FIG. 1)
21
EN
OFF
off on
ON