Important Warnings; Mounting Instructions - ERARD TWISTO 2497 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 1
GB
In order to ensure correct installation and acquaintance with this product, we recommend

Important warnings

• This Twisto is designed to accommodate flat screens of
up to 66 lbs only.
• Long-term storage: Store the Twisto in a clean, dry and
temperate environment.
Recommended temperature of the storage area: Between
0°C and 40 °C. Relative Humidity tolerated: 85%
maximum, non-condensing.
• Set-up: Follow all of the instructions in this manual very
carefully and take all of the necessary precautions to avoid
bodily injuries and damage to the equipment.
ERARD cannot be held responsible in the event of an
incident resulting from insufficient protective measures.
The Twisto can only be installed inside a building, and on
a flat support.
Never place the Twisto on the electrical cables as this
may result in damage to the power cord (risk of fire or
electrocution).
• When the Twisto is in use, ensure the following
Unpacking
Unpack all of the parts and check to ensure that all of the
parts shown on the drawing on page 14 are in proper
condition.
To help protect the environment, use the appropriate

Mounting instructions

Refer to page 14.
Start-up
• 4-in-1 remote control: Refer to the instructions provided
with the remote control. To enable the battery to function,
pull the tab at the bottom of the remote control to remove the
plastic film.
Press the <lift> key to access the Twisto pivoting functions.
To pivot the Twisto, use the following keys: left , right ,
and Up
arrow, aiming at the sensor located on top of the
Twisto, or using the walls and ceiling to reach the sensor by
signal refection (see page 19).
Adjusting the stops and preference position
(Left/right and preference)
Note: The factory settings are made for the maximum left
and right stop positions (+/- 30°) and for the preference
position: screen parallel to the fixation wall (in the centre).
ERARD - 38231 PONT DE CHERUY - F
Thank you for buying the TWISTO cabinet.
you read this manual carefully before assembly and use.
precautions are adhered to: No obstacle should hinder
the movement of the screen.
Provide for the necessary clearance space around the
Twisto and screen set: minimum 3,94'' above; 3,94''
below and 1'' behind the screen beyond the right and left
stops.
Do not position any objects next to the Twisto that may
hinder the movement of the screen on its support
Do not allow access to its mechanism, or restrict the
performance of the stops enabling the screen movement to
come to a halt, otherwise these may be crushed or pinched
during operation.
Always ensure children are at a safe distance from the
equipment when in operation.
Do not swing on the Twisto.
The system should not operate continuously. It should not
perform more than 10 cycles to the left/right per hour.
• Handling: Always move the Twisto without its load
(without the screen).
recycling and discarding methods for the packaging items.
The boxes used for the packaging of this product may be
recycled or re-used.
• Plug in the Twisto power supply cable.
• The screen rotation movements are continuous as long as
one of the directional keys (left
down. The movement stops when the key (left or right) is
released.
• Pressing the Up
preference position, adjusted at the factory. Pressing one of
the left or right arrows interrupts the cycle via which the
Twisto moves back into its preference position.
You may adjust other stop (left, right) positions and another
preference position to restrict the movement of the screen
during rotation, to prevent collision with objects around it
and to provide for optimum visual comfort.
4
ref. 2497 - Indice 02/2006
or right
arrow) is held
arrow brings the Twisto back into its
- Réalisation :
dpi
- 04 78 50 15 16

Publicité

Table des Matières
loading

Table des Matières