Red Dragon VT 3-30 C Instructions D'utilisation page 9

Masquer les pouces Voir aussi pour VT 3-30 C:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

For More Information:
Consult your local LP Dealer, Flame Engineering, NPGA, or NFPA Pamphlet 58.
This information is provided as a general guide for safe LP-Gas use and in no way
constitutes a complete safety program.
Troubleshooting Your Torch Kit Operation:
For more info go to www.flameengineering.com
I have only a weak/wimpy flame?
You are probably turning on your propane tank and torch kit too quickly. There is a
safety valve located in the P.O.L. fitting that connects your hose to your propane tank.
This feature is there to restrict propane in the event of an accident such as the hose
being cut or damaged. If the kit is turned on too quickly the safety valve is activated
and will restrict the flow of propane resulting in a very small, flickering, unusable
flame. See page 5 for instructions on properly starting and operating your torch kit.
Last time I used my torch kit it worked great, now it will not light?
There is an orifice located inside your torch that may be plugged. In the Mini Dragon™
torch, there is an orifice at the bottom of the torch were the flame comes out, as well as
in the fitting that screws into your handle. In other torch kits, the orifice is located at the
bottom of the torch only. The orifice is the pin sized hole in the middle of the fitting.
If this hole is restricted, the propane cannot properly flow through the torch. With the
torch kit turned off and the hose disconnected from the propane tank, locate the orifice
and clear area of debris such as cob webs, rust and dirt. You may use a small piece of
wire, or compressed air to clear the orifice. NEVER us water as this may disrupt the
performance of your torch kit. See also instructions for properly starting you torch kit.
I am experiencing flame out when I am trying to flame my weeds.
If your flame goes out when you try to flame your weeds, you may be holding the torch
to close to the ground and/or weeds. Fire needs oxygen to burn so it is easy to snuff out
the flame if you get to close, especially for small flame weeding models. Try holding
your torch kit farther away.
What is the small white pill/packet for?
This is your pipe thread sealant to be applied to all connections of you propane torch
kit, except the P.O.L. Excess Flow valve to your propane tank. See your instruction
manual for instructions on properly testing you torch kit for leaks. See page___ for
assembly instructions.
My hose P.O.L. fitting does not seem to fit into the propane tank?
The fitting that screws into the propane tank (P.O.L. Excess Flow Valve) has a left hand
thread therefore will screw into the tank to the left, instead of most threads that screw
to the right. It will screw into the inside of the propane tank valve. This P.O.L. fitting
will fit any standard propane tank, however may not screw all the way into the tank
depending on the style of tank that you have. Be sure that the P.O.L. fitting fits snug
into the propane tank if there are threads exposed. We recommend tightening
the connections to the tank with a wrench. See page 2 for assembly instructions.
9

Publicité

Table des Matières
loading

Table des Matières