Red Dragon VT 3-30 C Instructions D'utilisation page 3

Red Dragon Back Pack Tank Mounting Instructions
For Models: • BP2512C • BP2512SVC
1. Place Bottom Tank Ring onto Bottom
Tank Mounting Bracket.
2. Line up one of the large holes on the
Top Tank Ring with the hole on the Top
Tank Mounting Bracket on the back
pack. Secure with bolt, fender washer
and wing nut as shown.
The propane supply cylinder used with this torch should be no less than 20 lb.
capacity (except for the BP 2512 C and BP 2512 SVC) and must be designed, fab-
ricated, tested and marked in accordance with regulations of the U.S. Department
of Transportation, the Canadian Transport Commission or the Interstate Commerce
Commission. Supply cylinders must be arranged to provide for vapor withdrawal
from the operating cylinder.
1. Inspect the nut/nipple of the P.O.L. connection on the LP-Gas hose. Check for
dents or physical damage. The O-ring should be present on nipple fitting. If damage
is evident, call for replacement parts.
2. Be certain the supply cylinder valve is fully turned off. Remove the protective
plastic plug from the cylinder valve outlet connection.
3. Connect the P.O.L. nut/nipple fitting on the hose to the propane supply cylinder
by turning the left hand threaded P.O.L. nut counter clockwise into the cylinder
valve outlet. Snug the connection tight with a wrench. DO NOT OVER TIGHTEN.
4. Slowly open the cylinder valve 1/4 of a turn. Check all LP-gas connections for leaks
using soapy water or suitable leak detection solution. DO NOT USE MATCHES OR
OPEN FLAME TO CHECK FOR LEAKS. Do not attempt to operate the torch if
there is evidence of a leak or at any time the odor of gas is detected.
Connecting To The Supply Cylinder:
1/2" x 1" Bolt
Bottom Tank
Mounting Bracket
Top Tank
Mounting Bracket
1/2" Fender Washer
1/2"
Wing Nut
Top Tank Ring
Bottom Tank Ring
3