john deer D100 Série Manuel D'instructions page 11

INSTALL WEATHER ENCLOSURE SHELL CONTINUED...
7
U
Unpack the fabric weather enclosure shell [U], discard any packing tissue and
unfold on a soft surface, like grass or a tarp. This will prevent scratches to the
clear windows. Unzip the doors to aid in installation.
Open engine cowling before installing weather enclosure shell [U].
WARNING
This step helps seal the weather
enclosure against the entrance of
carbon monoxide gas. Breathing
carbon monoxide gas can cause
unconsciousness or death.
Follow this step closely.
10
Tuck the gas vapor shield under rear mounting bracket [H].
8
Find the front of the weather enclosure shell. It has a stretch material skirt on the
bottom. Gently pull the weather enclosure shell over the weather enclosure frame
on your riding mower being careful not to scratch the windows.
Match up each outside corner to the frame and make sure the weather
enclosure is centered on the frame.
9
Locate the gas vapor shield attached at the back of the weather enclosure shell.
11
H
Attach the gas vapor shield to the rip-and-grip strips installed under the seat.
Be careful not to get any shell material caught or pinched when closing.
11
D100 SERIES AND S200 WEATHER ENCLOSURE
Gas Vapor
Shield