Installation Information; Packaging And Unpacking; Installation Area; Electrical Connections - forcar BM1780 Mode D'emploi Et D'entretien

Packaging and unpacking

The machine is packaged in cardboard with polystyrene inserts
to guarantee full integrity during transport.
•
Handle the packaging according to the instructions.
•
Open the packaging and check the integrity of all
components. Keep packaging for future moves.
• Lift the machine as indicated and place it in the installation
area.

Installation area

The arranged area must be suitably illuminated and an electrical socket must be available. The resting
surface must be sufficiently ample, even and dry. The machine must be installed in rooms with non-explosive
environments. In any case, installation must also be performed in consideration of the work safety laws in
force.
Room conditions table
Descriptions
Working temperature
Storage temperature
Relative humidity
Dustiness

Electrical connections

DANGER – WARNING: Electrical connections to the supply
mains must be performed by qualified personnel.
Verify the efficiency of the grounding system in the building. Make sure that
line voltage (V) and frequency (Hz) correspond to those of the machine
(See the identification plate and wiring diagram). The machine is equipped
with a power cord that connects to a multi-polar plug. The plug is to be
connected to a wall switch equipped with a circuit breaker.
0÷35 °C (32÷95 °F)
-15 to +65 °C (from –6.8 to +149 °F)
Maximum 80% with 20 °C room temperature
Maximum 50% with room temperature between 20÷60 °C
Less than 0.03 g/m³
7
INSTALLATION
INFORMATION
Values
Connection
single-phase
230V – 1Ph
2