Dry Operation; Temporary Operation - d2itsu ASD 9U2 Manuel D'instructions

06Manual 22Daitsu ENG 21/12/06
Economic operation
When your push ECONO button during cooling, heating
(cooling only type without), or AUTO operation, the air
conditioner will start following operation. The fan speed will
be automaticaily controlled. In the operation suppression
zone where capacity is kept to the minimum, overcooling is
prevented by raising the temperature setting by 1
hour and by 2-
temperature is thus regulated between the operation
suppression zone and the set temperature. (it depends on
the outdoor temperature.)

Dry operation

The dry mode will automatically select the cooling dry
operation based on the difference between the set tempera-
ture and the actual room temperature.
The temperature is regulated while dehumidifying by
repeating turning on and off of the cooling operation or fan
only.
The fan speed indicator will display AUTO and low speed
will be used.

Temporary operation

Temporary operation This function is used to operate the
unit temporarily in case you misplace the remote controller
or its batteries are exhausted.
• Set the TEMPORARY switch to the AUTO position in order to
start the automatic operation.
• The COOL position is provided for test runs of the unit, and
automatic temperature control is cut off at this position. Never
use the position for ordinary operation.
16:17 Página 79
ADJUSTING AIR FLOW DIRECTION
o
C after 2 hours of operation. The room
o
C after 1
79