Placing The Batteries - König Electronic SEC-DUMMYMS10 Mode D'emploi

Dummy Motion Sensor
Introduction:
This professionally looking dummy motion sensor has a deterring effect on burglars. It is equipped with
a LED indicator that flashes every 20 seconds and is easy to install.
• We recommend that you read this manual before installing/using this product.
• Keep this manual in a safe place for future reference.
Specifications:
• Housing: plastic
• IP protection: only for indoor use
• Battery: 2x AAA 1.5 V (not incl.)
• Dimensions: 58 × 106 × 38 mm (bracket not incl.)
• Weight: 42 g (batteries not incl.)

Placing the batteries:

1. Open the battery compartment at the
backside of the motion sensor.
2. Place two 1.5 V AAA batteries conforming to
the polarity marking inside the battery
compartment.
Close the battery compartment after placing
the batteries.
ENGLISH
2