Remedy Of Faults; Wear Parts - Pontec PondoMatic 2 Notice D'emploi

Remedy of faults

Malfunction
The unit does not perform its suction function
The unit does not reach its full capacity
The collection container does not run empty,
the unit does not prime
Low suction capacity

Wear parts

Foam filters and valve rubbers filters are wearing parts and are, therefore, not covered by our warranty.
Storage
Empty out the collection container and clean the unit. Store in a dry, frost protected room, inaccessible to children.
Disposal
Do not dispose of this unit with domestic waste! For disposal purposes, please use the return system provided.
Disable the unit beforehand by cutting off the cables.
Cause
Drain hose incorrectly fitted
Excessive height difference between water
level and unit
Dirt has accumulated in the foam filter, in the
suction tube or in the suction hose
Dirt has accumulated in the area of the non-
return valve at the drain hose preventing it from
closing properly
The collection container cannot drain
Collection container and drain hose are soiled
The more tubes are used, the higher the tube
frictional resistance. The suction capacity
reduces.
Remedy
The non-return valve must be located at the
free end of the drain hose
Places the unit at water level height
Remove soiling
Remove soiling
Lay the drain hose without kinks.
Provide slight gravity for the drain hose.
After draining, almost no water should remain in
the collection container.
Remove soiling
Hold the suction hose as flat as possible to
improve the suction performance
- GB -
9