Using The Seat Heater; Guarantee - Waeco MagicComfort MSH60 Instructions De Montage Et De Service

MagicComfort MSH60, MSH601
Electrical connection
The seat heater MagicComfort MSH60 has one switch each for the driver's
and passenger seats, the seat heater MagicComfort MSH601 only one for
the seat chosen.
The complete circuit diagram can be found in fig. h, page 6.
A
NOTICE!
Ensure it has been securely fitted, particularly in the area of the
seat rails.
➤ Find a suitable place for installing the seat heater switch.
If possible, use the blanking plugs provided for this purpose.
Ensure that there is enough room behind the panel for the installation of
the switch.
➤ Mark the switch cut-out using the template provided (fig. g, page 5).
➤ Cut out the marked area with an appropriate tool.
➤ Install the switch into the cut-out (fig. d, page 5).
➤ Install the ready-made wiring harness so that the cables cannot bend or
fray (fig. e, page 5).
8

Using the seat heater

➤ Switch on the seat heater using the corresponding switch (level
vel ).
➤ To switch the seat heater off: Put the corresponding switch into the middle
position.
9

Guarantee

The statutory warranty period applies. If the product is defective, please
contact the manufacturer's branch in your country (see the back of the
instruction manual for the addresses) or your retailer.
For repair and guarantee processing, please send the following items:
 Defect components
 A copy of the receipt with purchasing date
 A reason for the claim or description of the fault
EN
Using the seat heater
or le-
25