Intended Use; Technical Description; Installing The Seat Heater - Waeco MagicComfort MSH60 Instructions De Montage Et De Service

Intended use

5 Intended use
The seat heater MagicComfort MSH60 (Art. no. 9101700025) and MSH601
(Art. no. 9101700026) are designed for installation in the front vehicle seats.
A
NOTICE!
For vehicles equipped with side airbags in the seat backrests,
seat occupancy detection or child seat detection, observe the ve-
hicle manufacturer's specifications.
6

Technical description

The heating elements for the seat heater MagicComfort MSH60 and
MagicComfort MSH601 can be installed in the driver's seat and in the pas-
senger seat.
The shape of the seat is not altered by the heating elements.
The seat heater is operated using a switch.
7

Installing the seat heater

7.1 Tools required (fig. 1, page 3)
For installation and assembly you will need the following tools:
 Drill bit set (1)
 Drill (2)
 Screwdriver (3)
 Set of ring or open-ended spanners (4)
 Measuring ruler (5)
 Hammer (6)
 Centre punch (7)
To make and test the electrical connection, the following tools are required:
 Diode test lamp (8) or voltmeter (9)
 Crimping tool (10)
 Insulating tape (11)
 Hot air blower (13)
 Soldering iron (14)
 Solder (15)
22
MagicComfort MSH60, MSH601
EN