Rowenta EP7910 Mode D'emploi page 11

NOT EP7910-7970-8975E0 017473
- Set the switch to "1".
- Start exfoliating with a slow, gentle up and down movement.
When using the Micro-Peeling function for the first time or if your skin is very
delicate, we recommend:
1. skin is wet before peeling, use cotton wool or a flannel to do this
2. making slow and gentle rotating movements when using the appliance3. not to
use the appliance more than twice on the same area.
• Replacing the exfoliating band
- Press the release button to remove the Exfoliator Head from the epilator.
- Using the plastic end of the cleaning brush unclip the band as follows:
1. Turn the Exfoliator Head over and hold it in place by gripping the edges between your
thumb and forefinger.
2. Turn the band so that its groove comes round to the central position.
3. Insert the end of the cleaning brush in the groove and push to eject the band.
4. Insert the new band by slotting the fins (b) of the exfoliator unit in the groove of the
band and pushing until it clicks!
a
7-LEG HAIR REMOVAL
For optimum epilation, we recommend that you tilt the epilator
slightly towards your skin in the direction of epilation, as shown in
the diagram.
- Move the switch to the on position "2 ".
- The switch must always remain visible during use.
31/10/06 15:02
b
- Shave against the lie of the hair,
slowly and without pressing, with
the shaver perpendicular to your
skin.
9
Page 9