General Specification S - koban KMOS-01 Mode D'emploi

True RMS Multimeter
6.General Specification
Enclosure
Shock (Drop Test)
Diode Test
Continuity Check
PEAK
Temperature Sensor
Input Impedance
AC Response
AC True RMS
ACV Bandwidth
Crest Factor
Display
Overrange indication
Auto Power Off
Polarity
Measurement Rate
Low Battery Indication
Battery
30
Double molded, waterproof
6.5 feet (2 meters)
Test current of 0.9mA maximum, open circuit
voltage 3.2V DC typical
Audible signal will sound if the resistance is less
than 25 (approx.), test current <0.35mA Ω
Captures peaks >1ms
Requires type K thermocouple
>10MΩ VDC & >9MΩ VAC
True RMS
The term stands for "Root-Mean-Square" which
represents the method of calculation of the voltage
or current value. Average responding multimeters
are calibrated to read correctly only on sine waves
and they will read inaccurately on non-sine wave
or distorted signals. True rms meters read
accurately on either type of signal.
50Hz to 100000Hz
< 3 at full scale up to 500V, decreasing linearly
to < 1.5 at 1000V
50,000 count backlit liquid crystal with bargraph
"OL" is displayed
5-3 minutes (approximately) with disable feature 0
Automatic (no indication for positive); Minus (-)
sign for negative
2 times per second 0
" " is displayed if battery voltage drops below
operating voltage
One7.4V