Factory Reset - Scansonic DA300 Guide D'instructions

Programme type
This describes the style of the programme that is being broadcast. If the information is not available, the display
will show "<Programme Type>".
Ensemble/Multiplex (Group name)
The Ensemble/Multiplex is a collection of radio stations that are bundled and transmitted together in a single
frequency. There are national and local multiplexes, local ones contain stations that are specific to that area.
Note: Press and hold the INFO button for longer than 2 seconds, the software version number will be displayed.
FM radio
1. To select FM, repeatedly press the MODE button until the display shows "Switch to FM"; the FM frequency will
be finally displayed.
2. To activate auto search, press and hold the SCROLL control until it starts to scan up or down the frequency
band, the display will show "Searching ... > ." or "Searching ... < .", and it will stop automatically once a station
has been found. (F6) (F7)
3. To activate manual tuning, first press on the SCROLL control once and when the display shows < Tuning >,
rotate the SCROLL control to your desired frequency.
4. To select the FM stereo/mono reception, first press on the MENU button once, and when the display shows
"FM Audio setting", press the SCROLL control to enter into the menu, then rotate the SCROLL control
followed by pressing on it to confirm between the "Auto" or "Mono" selection.
Note: The radio will automatically switch between stereo and mono mode, but you can override this and switch
this function manually which is helpful for poor signal reception.
STORING AND RECALLING STORED STATIONS
In either DAB or FM mode, you can store up to 10 stations to the favourite presets; this will enable you to get
direct access to your favourite stations.
1. To store a preset, first tune to your desired station, then press and hold the MEMORY button, the display will
show "Empty preset 1", and the preset number will flash. (F8)
2. Rotate the SCROLL control to select your desired station preset number followed by pressing on the same
control to confirm your selection, the display will show "Preset # saved". (F9)
3. To recall a preset station, first press the MEMORY button once, then rotate the SCROLL control to scroll up or
down the presets that you have stored. When the display shows your desired preset number, stop the rotation
and press on the SCROLL control to confirm. If the preset hasn't been allocated a station, the display will show
"Empty preset #".

FACTORY RESET

When you move the radio to another part of the country, your pre-tuned and stored DAB stations may no longer
be available. If this is the case then you will need to reset your radio back to its original factory settings; to perform
a factory reset, please do the following:
1. Plug the radio to the AC mains and press the
2. Press and hold the MENU button until the display shows "Press SELECT to confirm reset".
3. Release the MENU button and press on the SCROLL control once, the display will first show "Restarting ..."
and after the reset is completed, the radio will go to standby.
button to turn the radio on.
UK-4