Features And Controls; Switching Your Radio On For The First Time - Scansonic DA300 Guide D'instructions

Radio numérique dab+dab/fm avec une fonction horloge, deux heures de réveil et la fonctionnalité bluetooth
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

Service/Maintenance
- To reduce the risk of electric shock, do not remove screws. The unit does not contain any user-serviceable
parts. Please leave all maintenance work to qualified personnel.
- Do not open any fixed covers as this may expose dangerous voltages.
- Ensure to unplug the unit from the mains socket before cleaning.
- Do not use any type of abrasive pad or abrasive cleaning solutions as these may damage the unit's surface.

FEATURES AND CONTROLS

1. VOLUME/SCROLL & OK/►/II
CONTROL
2. LCD DISPLAY
3. INFO/ BUTTON
4. MENU/ BUTTON
5. MODE BUTTON

SWITCHING YOUR RADIO ON FOR THE FIRST TIME

When the radio is connected to the AC power for the first time, it will be in standby mode. The display backlight
will be on for a few seconds, the display will first show the greetings and finally the clock. Press the
once to turn the radio on, it will then automatically enter into the DAB mode and perform auto scan function.
Clock setting
The clock will only set and be updated if you can receive DAB signals in your location. In order for the clock to
synchronise to the current local time you must leave it one DAB station for a short period. Manual clock setting is
not required.
LISTENING TO YOUR RADIO
Hints for better reception
This radio carries a single DAB/FM telescopic antenna, to obtain the best performance, you should fully extend
the antenna and adjust its position as well as the direction until you find the best reception. For ideal DAB
reception, always maintain the antenna in an upright vertical position is highly recommended.
DAB mode
If the radio is powered up and switched on for the first time, it will automatically enter into the DAB mode and
perform auto scan function. During the scan the display will show "Scanning ..." together with a slide bar that
indicates the progress of the scan and the amount of stations that have been found so far. (F1) (F2).
Once the scan has finished, the radio will select the first alphanumerically found station. To explore the found
stations, first press the SCROLL control once, then rotate the same control, and when you find a station that you
would like to listen to, press on the SCROLL control.
Note: If there is no stations found after auto scan, the radio will then enter into the Tune Select Menu, you can
now rotate the SCROLL control followed by pressing on the same control to select "Manual tune" or "Autoscan"
for stations.
6. SPEAKER
7.
BUTTON
8. ALARM/SNOOZE BUTTON
9. SLEEP BUTTON
10. MEMORY BUTTON
11. RODANTENNA
UK-2
12. HEADPHONE JACK
13. AUXIN SOCKET
14. USB PORT
15. AC CORD SOCKET
button

Publicité

Table des Matières
loading

Table des Matières