Olympia PS 315.7 Mode D'emploi page 9

Problem
Device does not work
Device does not work after
lengthy operation or
stops during operation
Paper jam
Device malfunctions
Cause
Is the mains cable plugged
properly in the socket?
Is the sliding switch set to
AUTO?
Does the motor not start
when paper is fed in?
Was the device in constant
operation for some time?
Is the surface of the device
warm?
Have you inserted
more than
15 sheets (315.7)
7 sheets (307.4C)
Has the paper not been
inserted straight in the in-
feed slot?
Remedy
Plug the mains cable into
the socket properly.
Set the sliding switch to
AUTO.
Push the paper into the in-
feed slot so that it touches
the sensor in the centre.
Pull out the mains plug
from the socket and allow
the motor to cool down to
room temperature.
Set the sliding switch to
REV to push back the
paper. Switch the device to
AUTO again to shred the
paper remaining in the cut-
ting unit.