LEGRAND 430 522 Manuel D'utilisation page 35

CHECK POINTS BEFORE OPERATION
• Before turning on the system, check if the wire(s) and cable(s) are connected properly.
• Check if the camera ID on the controller is properly selected. The camera ID must be identical to that of the
target camera. The camera ID can be checked by reading the DIP switch of the camera or on OSD.
• If your controller supports multi-protocols, the protocol must be changed to match to that of the camera.
• Adjust the DIP switch after turning off the camera. If you changed the camera protocol by changing the DIP
S/W, the change will be effective after you reboot the camera.
• Since the operation method can be different by controllers, refer to your controller manual if the camera can
not be controlled properly. The operation of this manual is based on the standard Pelco® Controller.
35