Product Specification; Operating Controls; For Your Safety; Intended Use - Bosch AXT Rapid 2000 Instructions D'emploi

F 016 L70 461 - GB Seite 2 Freitag, 7. Juli 2006 1:40 13

Product Specification

Shredder
Part number (TYP)
Rated power, S 6 (4/6 min)
Rated power, S1
No-load speed
2)
Capacity max.
2)
Branch diameter max.
Weight. approx.
Protection class
Serial Number
1)
The S 6 operating mode (40 %) indicates a load profile of 4 min load and 6 min idle time. For practical application, con-
tinuous operation is permitted.
2)
depending on the hardness of the wood.

Operating Controls

1 Feed intake
2 On/Off switch
3 Securing knob
4 Mains plug**
5 Ventilation slots
6 Undercarriage
7 Collection bag *
8 Discharge chute
9 Hooks for collecting bag
10 Serial Number
11 Cover
12 Allen Key
13 Prodder
*Optional accessory
**Country specific
*Not all of the accessories illustrated or described are
included as standard delivery.

Intended Use

The product is intended for cutting of fibrous and
woody garden waste for composting.
When operating the machine with a generator, a unit
with a power rating of 4 kVA is necessary.
13 • F 016 L70 461 • TMS • 07.07.06
AXT Rapid 2000
3 600 H53 5..
1)
[W] 2000
[W] 1800
[rpm] 3650
[kg/h] 80
[mm] 35
[kg] 11.5
/ II
See serial No 10 (rating plate) on machine.
English - 2
AXT Rapid 2200
3 600 H53 6..
2200
2000
3650
90
40
12
/ II

For Your Safety

Warning! Switch off, remove plug from mains
before adjusting, cleaning or if cable is cut,
damaged or entangled.
The blades continue to rotate for a few sec-
onds after the machine is switched off.
Caution – do not touch rotating blades.
Electrical Safety
Your machine is double insulated for safety and re-
quires no earth connection. The operating voltage is
230 V AC, 50 Hz (for non-EU countries 220 V, 240 V
as applicable). Only use approved extension cables.
Contact your service agent for details.
Extension cords/leads should only be used if they
comply with H05VV-F or H05RN-F types.
If you want to use an extension cable when operat-
ing your product, only the following cable dimen-
sions should be used:
2
- 1.0 mm : max length 40 m
2
- 1.5 mm : max length 60 m
2
- 2.5 mm : max length 100 m
It is recommended for increased electrical safety to
use a Residual Current Device (RCD) with a tripping
current of not more than 30 mA. Always check your
RCD every time you use it.
The couplings of connection leads must be protected
against splashes and the coupling sockets on the
leads must be made of rubber or coated with rubber.
Fixing means for the connection leads must be used.
The connection lead must be inspected for signs of
damage at regular intervals and may only be used if
in perfect condition.
If the supply cord is damaged, it must be replaced by
a Bosch Service Centre.