U.S.Robotics 8004 Guide D'installation Rapide page 9

Step 3: Configure the basic connection settings.
Windows XP and Me users: If Universal Plug and Play launches, follow the on-screen
instructions instead of steps 1 and 2 below, then start with step 3.
1. Launch your Web browser.
2. In the location or address line, type http://192.168.123.254 and press ENTER to start
the router Web User Interface.
3. Click Log in—there is no default password.
Select Primary Setup from the menu, and then click Change.
4.
5. Select your WAN type. Depending on your WAN type, you may need to enter connec-
tion information. If you are unsure about any connection information required by the
setup process, contact your Internet Service Provider. When finished, click Save.
6. Verify your Internet connection by launching a Web browser and going to
www.usr.com/productreg
If your Internet connection is not successful, refer to "Troubleshooting" in this guide.
If your Internet connection is successful, register your product. U.S. Robotics also rec-
ommends that you make a backup of your new configuration settings as follows:
1)
2)
3)
4)
Congratulations! The installation procedure is complete!
For configuration details, regulatory information, and warranty information, refer to the
Guide on the U.S. Robotics CD-ROM.
Troubleshooting
I can't connect to the router's Web User Interface.
Possible Solution 1:
Make sure that all the Ethernet cables are properly and securely connected and that the power
cord is plugged in.
Possible Solution 2:
Make sure that you correctly performed all the steps in the "Before You Begin" section of the
Guide
on the U.S. Robotics CD-ROM. If your computer was configured to use a static IP address,
you must now reconfigure it to Obtain an IP address automatically.
Select the Toolbox menu.
Click Backup Setting.
Your system will prompt you to save or open the file. Select Save.
Browse to the location at which you want the backup file saved and click
Save.
User
User
5