U.S.Robotics 8004 Guide D'installation Rapide page 10

Possible Solution 3:
Make sure that your PC is using an IP address that is within the default range of 192.168.123.xxx.
Make sure the address of the subnet mask is 255.255.255.0. If necessary, the Default Gateway
should be 192.168.123.254. To verify these settings, perform the following steps:
Windows XP, 2000, or NT users:
1. Click Windows Start, and then click Run.
Type cmd and click OK.
2.
3. At the DOS prompt, type ipconfig /all and press ENTER.
4. Check the IP Address, Subnet Mask, Default Gateway, and DNS server data to make
sure they are correct.
If the information is not correct:
1)
2)
Windows Me, 98, or 95 users:
1. Click Windows Start, and then click Run.
Type winipcfg and click OK.
2.
3. Check the IP Address, Subnet Mask, Default Gateway, and DNS server data to make
sure they are correct.
If the information is not correct, click Release All, and then click Renew All.
Possible Solution 4:
Follow the instructions below to verify the connection setting of your Web browser and to verify
that the HTTP Proxy feature of your Web browser is disabled. This procedure ensures that your
Web browser can read the configuration pages inside your router.
Internet Explorer users:
1. Launch Internet Explorer.
2. Click Tools, Internet Options, and select the Connections tab.
3. Select Never dial a connection and click Apply.
4. Click the LAN Settings button.
5. Clear all the check boxes and click OK.
Click OK.
6.
Netscape Navigator users:
1. Launch Netscape Navigator.
2. Click Edit, Preferences.
In the Category window, double-click Advanced.
3.
4. Click Proxies, click Direct connection to the Internet, and then click OK.
6
Type ipconfig /release and press ENTER.
Type ipconfig /renew and press ENTER.