Installation Instructions; Antenna Installation - PNI Escort HP 8000L Manuel De L'utilisateur

MICROPHONE DESCRIPTION:
2 3 4
UP ASQ DOWN
1

INSTALLATION INSTRUCTIONS:

Before installing the radio in your vehicle, choose the most suitable location so you can use it without being
disturbed while driving.
To install the radio, use the mounting bracket and the accessories in the package. The screws must be securely
clamped to avoid vibration of the radio while driving. The mounting bracket can be positioned above or below
the device and can be tilted depending on the installation mode (under the dashboard or under the ceiling).
WARNING: Power the radio to 12V only.
Installation of the central unit:
Before powering the radio, make sure that the power knob is fully turned to the left.
The power cord of the radio includes a protective fuse on the red wire. Connect the radio's power cable to
the car's electrical system paying attention to the polarity (even if the radio has protection against polarity
reversal).
Connect the red wire to the positive terminal (+) and the black wire at the negative terminal (-) of the vehicle's
electrical system.Check the connections were made correctly to prevent them from being disconnected or
possibly short-circuiting.
WARNING: Do not replace the fuse with one with a higher value. The fuse from the actory has 2A.

Antenna installation:

To use this radio, you need an antenna that operates at 26-28MHz.
To install the antenna, call a specialist.
Before connecting the antenna to the radio, it is necessary to check it with a specialized device to prevent the
transmission circuit failure.
Typically, the antenna should be positioned on the highest side of the vehicle without being obstructed by
1. PTT button – Push to Talk
2. Increase channel number
3. Enable/disable ASQ function
Decrease channel number
4.
5
EN