Camplux CM264 Manuel D'utilisation Et D'entretien page 23

www.camplux.com
(OPTIONAL) REMOTE CONTROL -
22
CONNECTION, INSTALLATION AND SET
(For Panel Control / Remote Control & Remote Control Units)
Panel Control/Remote Control and Remote Control units will work with either one or two remote controls. If
two remotes are desired, a wire connector will need to be provided. To connect the remote control.
1. For one control: Plug the aviation joint into the socket directly on the water heater (see illustration below)
Remote Control
Aviation Joint
2. For two controls: First, cut off the aviation joints on the two controllers, plug one into the socket on the water
heater (length is dependent on your requirements), and throw away the other. Then connect the wires of the
aviation joint to the inlet wire of the connector, and connect the two remote control to the outlet wires of
connector.
INSTALLATION OF REMOTE CONTROL
1. Remove the front cover of the Remote Control. (See illustration below)
Remote Control
Front Cover
Control Base
2. At installation site, mark and screw two holes with 0.24" with 1.2" depth. Insert 2 rubber screws into the
holes. Place the remote control against the wall, align the holes of control with the holes in the wall, and fasten
them with wood thread screws. (See illustration below)
(844) 538-7475
3330-A Marathon Ct Charleston, SC 29418 support@camplux.com
Visit Us: Camplux.com