Helpful Hints; Cleaning And Care - ThermoPro TP-17 Mode D'emploi

Masquer les pouces Voir aussi pour TP-17:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

again to restart the timer.
If you are using the timer and thermometer at the same
time, you may slide the selector switch back to the cook
position during the timing session to set or view the cooking
EN
temperatures. The timer will continue the countdown .
The alarm will sound when it reaches 00:00 and you can
silence the alarm by pressing any button.
Count up Timer:
Slide the mode selector switch on the back of the device
to the timer position
Press the ▲/HR and ▼/MIN buttons at the same time to
clear the timer setting to 00:00.
Press S/S button to start count up timer. Press it again
to stop/re-start the timer.
The timer will stop when it reaches 99 Hour: 59 Minute.
If you are using the timer and thermometer at the same
time, you may slide the selector switch back to the cook
position during the timing session to set or view the
cooking temperatures. The timer will continue counting
up .
Note: When setting the timer, you can press and hold ▲
or ▼ for fast setting.
.
-34-

Helpful Hints

If the unit display LLL or HHH instead of the probe
temperature, wait for probe to reach room temperature.
If LLL or HHH is still displayed it is likely the internal
probe wire has shorted out either through moisture or
heat damage.
Do not immerse the probe in water while cleaning.
Do not allow the probe or probe wire to come into
contact with flames.
Within the warranty period, please contact our customer
service and we will send you a replacement probe at no
charge.
If the temperature displayed seems to read too high or
the temperature seems to increase too quickly, check to
make sure the probe tip is not poking through the food
to outside. Reposition the probe tip in the center of the
thickest part of food. Avoid touching bone or heavy fat
areas.

Cleaning and Care

The device is not waterproof. Do not expose plug of probe
or plug-in hole to any liquid, which will result in a bad
connection and faulty readings.
The probe and cable are not dishwasher safe. They must
-35-
EN

Publicité

Table des Matières
loading

Table des Matières