Using The Appliance - ECG AC 3020 HC Dual Mode D'emploi

USING THE APPLIANCE

For hygienic reasons, wipe the inside space of the car cool box with a sponge slightly moistened with a mild
solution of dish detergent before first use. Then wipe the space with a sponge moistened with clean water and
dry it.
When the handle is pushed back, the lid is closed and cannot be opened. Do not try to force the lid. The lid may
be opened when the handle points toward the front.
Warning: Always lift the car cool box by the handle. Risk of tipping over!
Note about cooling:
You can use 2 modes for cooling
1. Normal mode:
In this mode (switch is in the "NORMAL" position) the cooling operates in the energy class "D". The
temperature inside the cool box drops about 15–20°C below the outside temperature, if the outside
temperature is about 25°C.
2. ECO mode:
In this mode (switch is in the ECO position) the cooling operates in the energy class A++ and the
temperature inside the cool box drops about 6–10°C below the outside temperature, if the outside
temperature is about 25°C
Note about heating:
The heating operates only in the „NORMAL" mode and the internal temperature reaches about 55–65°C.
1. Place the car cool box on a flat surface, which ensures enough free space for proper functioning of the air
vents.
2. Make sure that the food and drinks placed in the car cool box are suitable for cooling at that temperature
and let them cool sufficiently before placing them in the device. We recommend that you pre-cool the
car cool box for at least 4 hours to keep the food cooled to the required temperature for as long as possible.
3. Connect 12V DC power canle to the cigarette lighter socket or 12V DC outlet in your car, or connect the AC
cable to the appropriate connector on the car cool box and into the AC voltage outlet.
4. Close the lid of the car cool box and secure it by turning the handle backwards.
Turn the switch on the control panel to the position COLD (cooling) or HOT (heating). According to the
5.
selected mode, green light (cooling) or red light (heating) turns on.
In the heating mode, the fan automatically turns on or off and thus regulates the temperature.
Warning: Before switching the car cool box from the cooling mode to heating mode and vice versa, the
car cool box must be switched OFF for at least 5 minutes!
6. The car cool box starts cooling/heating.
By turning the switch into the position OFF you will switch off the cooling/heating. If you will not use the
7.
device any more, unplug the cable from the cigarette lighter in your car or from the wall outlet.
Warning:
If you plug the cable in the cigarette lighter in the car, the ignition must be on to supply the power
to the car cool box.
We definitely do not recommend starting the vehicle with the car cooler connected. Always
unplug the car cooler from the car socket when starting the car.
The car cooler has a consumption of up to 7 A during operation, so it is necessary to have the car
battery in good condition and the circuit of the car socket protected by a fuse prescribed by the
vehicle manufacturer.
If there are multiple outlets in the electrical circuit, we recommend that you only have one
appliance connected at a time to avoid overloading the fuse and damaging the wiring.
Power saving tips
Choose a well ventilated place that is protected against direct sunlight.
8