Using The Appliance - ECG AC 3010 C Mode D'emploi

The appliance is designed to connect to a 12 V DC car socket (cigarette lighter), in a boat or a caravan, as well
as 220–240V mains power (if an MP 2500 converter is used, which can be purchased).
Warning: If you wish to keep medication cold, make sure that the cooling power of the equipment is suitable
for the medication.
The pockets located on the outside sides of the car cool box serve as a storage space. Objects stored there are
not being cooled.
WARNING: THE LARGE ZIPPER POCKET THAT COVERS THE MOTOR MUST BE LEFT EMPTY AND
For easier access, the lid of the cooling bag is equipped with a small window for removing and inserting small
items and with an inside pocket for small items (e.g. medication).
Since during the cooling the humid air inside the car cool box condenses, you can find drops of water on the
inside of the bag in case of long-term cooling. It is a normal phenomenon, wipe the condensation with dry
cloth if necessary.

USING THE APPLIANCE

GB
For hygienic reasons, wipe the inside space of the car cool box with a sponge slightly moistened with a mild
solution of dish detergent before first use. Then wipe the space with a sponge moistened with clean water
and dry it.
Warning: Do not use abrasive sponges or cleaning powder. Do not wash the car cool box under running
water and do not immerse it in water.
Note about cooling:
The temperature inside the cool box drops about 11-15 °C below the outside temperature, if the outside
temperature is about 25°C.
1. Place the car cool box on a flat surface, which ensures enough free space for proper functioning of the air
vents.
2. Make sure that the food and drinks placed in the car cool box are suitable for cooling at that temperature
and let them cool sufficiently before placing them in the device. We recommend that you pre-cool
the car cool box for at least 4 hours to keep the food cooled to the required temperature for as long as
possible.
3. Connect the 12V DC power cable to the cigarette lighter socket or other 12V DC socket in the car. Use the
MP 2500 AC converter (not included) to connect to a 220–240 V mains socket.
4. Close the lid of the car cool box.
5. The car cool box starts cooling.
6. You can turn off the cool box by pulling the power cable out of the socket.
Warning:
If you plug the cable in the cigarette lighter in the car, the ignition must be on to supply the
power to the car cool box.
We definitely do not recommend starting the vehicle with the car cooler connected. Always
unplug the car cooler from the car socket when starting the car.
The car cooler has a consumption of up to 7 A during operation, so it is necessary to have the car
battery in good condition and the circuit of the car socket protected by a fuse prescribed by the
vehicle manufacturer.
If there are multiple outlets in the electrical circuit, we recommend that you only have one
appliance connected at a time to avoid overloading the fuse and damaging the wiring.
Power saving tips
Choose a well ventilated place that is protected against direct sunlight.
Do not open the lid more often than necessary.
Clean the car cool box regularly.
38
OPEN DURING COOLING.