Leroy Merlin KL-1012 Mentions Légales & Consignes De Sécurité page 42

Note: There are only two positions for the stand. The left one is special for standing like fig. 1, the right one is
to fix the stand when use it like fig.2.
Fit the stand supplied to the front of the appliance (see fig.1)
Fold it forward and lay down the glue gun as in fig.1 before inserting the plug in the wall socket. Insert the glue
cartridges in the opening A (fig.1) of the appliance and push the plug into the wall socket. The glue gun will be ready
for use approximately 5 minutes. The best connections are obtained if the surfaces to be glued are clean and free of
grease. Apply the liquid glue in strips or drops(by pressing handle)
When gluing has finished, remove the plug from the wall socket and allow the appliance to cool on the stand.
The glue bar may be left in the appliance after use. The appliance needs no special maintenance. Glue residues may
be carefully removed from the nozzle if necessary when the appliance has cooled.
Warning！
Remove the plug from the wall socket when
the appliance is not in use.
Keep the appliance out of reach of children.
Keep the appliance away from water.
The hot glue and hot nozzle can cause burns.
If the mains cable or plug is damaged, don't
use the appliance until the damaged parts have
been replaced.
Remove lightly flammable or heat-sensitive
materials from around the nozzle.
Always keep the glue gun on the stand
during warming up.
If the supply cord is damaged, it must be
replaced by the manufacturer, its service agent
or similarly qualified persons in order to avoid
a hazard.