Troubleshooting Tips - GE GWS03ADWSS Manuel D'utilisation Et D'installation

Before you call for service...

Troubleshooting Tips

Save time and money! Review the charts on the following
pages first and you may not need to call for service.
Problem
Wine chiller does not
operate
Vibration or rattling
(slight vibration
is normal)
Motor operates for
long periods or cycles
Wine chiller too warm
10
Possible Causes
Wine chiller is unplugged.
The home circuit breaker
is tripped/the fuse is blown.
Temperature setting is above
room temperature.
Wine chiller is on
an uneven surface.
Normal when wine chiller
is first plugged in.
Often occurs when large
amounts of wine are placed
in wine chiller.
Door left open.
Hot weather or frequent
door openings.
Temperature control set
at the coldest setting.
Wine chiller is too close
to the wall.
Normal when wine chiller
is first plugged in.
Often occurs when large
amounts of wine are placed
in wine chiller.
Temperature control
not set cold enough.
Warm weather or frequent
door openings.
Wine chiller is too close
to the wall.
Door left open.
What To Do
• Push the plug completely into the outlet.
• Replace fuse or reset the breaker.
• This is normal. If wine is too warm, change
the temperature setting to a lower temperature.
•See the Leveling Legs section.
• Wait 12 hours for the wine chiller to completely
cool down.
• This is normal.
• Door is not self-closing. Always make sure that
the door is closed after opening.
• Check to see if a bottle is holding door open.
• This is normal.
• See About the control and settings.
• See the Installation Guidelines section
for the correct clearances.
• Wait 12 hours for the wine chiller to completely
cool down.
• This is normal.
• See About the control and settings.
• Set the temperature colder. See Control settings.
• See the Installation Guidelines section
for the correct clearances.
•Door is not self-closing. Always make sure that
the door is closed after opening.
•Check to see if a bottle is holding door open.