EN = North American English
A.0
General
A.1
Thule assumes no liability for injury to persons, damage
to movable or immovable property, loss of profit, or
any other loss or damage caused by the improper
mounting or use of the carrier, including but not limited
to mounting or use in conflict with the assembly
instructions, mounting instructions or any other
instructions given, in writing or verbally, by Thule or a
Thule dealer.
A.2
The carrier and its parts must not be modified in any
way.
A.3
Consult your Thule dealer if you have any questions
about the operation, use and limits of the carrier. Read
all of the instructions and warranty information carefully
before mounting and using the carrier.
A.4
The Safety instructions should be retained for future
reference and to ensure that any other users of the bike
carrier are familiar with its content.
B.0
Fitting
B.1
Check the assembly instructions to make sure that all
the necessary parts of the carrier
are present.
B.2
Read and follow the assembly instructions and the
recommendation list carefully, if the list
is included. Then fit the unit in the correct sequence by
following points 1, 2, 3 and so on.
B.3
Do not attempt to fit the carrier in any other way than
the way shown in the mounting instructions.
B.4
In the case of the roof-mounted carrier, if no special
fitting positions are given in the assembly instructions,
ensure that there is a minimum distance of 700mm
between the front and rear racks.
B.5
The load may not exceed the load carrier's width, and it
should be spread evenly across the load carrier and with
the low¬est possible center of gravity.
C.0
Loading
C.1
The maximum load for the carrier, as specified in
the assembly instructions, must not be exceeded. In
addition, the maximum load recommended for the
vehicle itself always takes priority over the load specified
in the assembly instructions. It is always the lower
recommended maximum load that applies and that
must not be exceeded.
C.2
The load must be carefully secured. Elastic bungees
must not be used.
C.3
Check and do not exceed the maximum weight per bike
specified in the mounting instructions.
C.4
The carrier is constructed to carry only standard bike
frames. Tandem bikes must not be transported on the
carrier. Always check and do not exceed the maximum
bike frame size (diameter) specified in the mounting
instructions.
C.5
In the case of bikes with carbon frames or forks, always
consult the bike manufacturer or dealer to check if you
are allowed to use the carrier.
C.6
Thule assumes no liability for any damage to carbon
frames or forks incurred during mounting and/or use of
the carrier.
C.7
All easily removable parts of the bikes must be removed
before transportation, including but not limited to child
seats, baskets, locks (if not permanently mounted) and
air pumps. These parts can become detached during
transportation because of increased air resistance and
vibration and can constitute a danger to other road
users.
20
D.0
Driving characteristics and regulations
D.1
Check the load fastenings regularly.
D.2
The vehicle driver is solely responsible for ensuring that
the carrier is in perfect condition and that the carrier
and load are securely fastened (even if fitted by a third
person).
D.3
Every time the carrier is used, check that the carrier is
securely fitted after driving a short distance (50km) and
then at regular intervals. If you notice any unusual noise,
movement of the load and/or carrier, different behaviour
of the vehicle or other unusual conditions, stop and
check that the carrier and load are secured correctly,
and in accordance with the mounting instructions.
D.4
The vehicle's total length and/or height may increase
when a carrier is mounted. The bikes themselves may
increase the vehicle's total width and height. Take special
care when reversing and/or entering garages or ferries
etc.
D.5
Replace any damaged or worn parts of the carrier
immediately. During transportation, all levers, bolts
and/or nuts must be tightened in accordance with the
mounting instructions.
D.6
Carriers fitted with a lock must always be in the locked
position. The keys must be removed and kept inside the
vehicle during transport.
D.7
Be aware that the vehicle's driving characteristics and
braking behaviour (including in curves) might change
and that the vehicle might become vulnerable to side
winds when the carrier is fitted.
D.8
The vehicle's speed must always be adjusted to the load
being carried and the current driving conditions, such
as the road type, road quality, wind conditions, traffic
intensity and applicable speed limits, but must under no
circumstances exceed 130 km/h. Applicable speed limits
and other traffic regulations must always be observed.
D.9
Be aware that wind noise may be generated during
transport and may vary depending on the vehicle and
load.
D.10 For reasons of fuel economy and environmental impact
as well as the safety of other road users, the carrier must
be removed from the vehicle when not in use.
E.0
Maintenance
E.1
Clean the carrier regularly using warm water or car
shampoo, especially when using or after using the carrier
in coastal areas (the effect of salt water) or during
periods when salt is applied to the roads (winter time).
E.2
Remove the carrier before using an automatic car wash.
E.3
When the carrier is removed from the vehicle, it must be
stored in a dry storage area. All the components of the
carrier must be stored safely. Remember to clean and
maintain the carrier in accordance with the instructions.
E.4
If you lose part(s) of the carrier or part(s) of the
carrier wear out, only use genuine Thule spare parts as
replacements. Spare parts can be purchased from your
dealer or manufacturer.
E.5
To ensure that you receive the spare parts quickly and
to avoid time-consuming queries, please provide the
relevant product details and the serial number when
placing an order or making an inquiry.
E.6
In order to ensure that you are able to replace lost or
defective keys as quickly as possible, note down the lock
and key number which can be found on your key and
lock.
5560149001