Other Options - Promax DT-202 Guide Rapide

Output Signal Error
-
If the TS ID of the demodulated signal does not match the value
defined in the "Input TSID" field, it does not remodulate the original
signal. The ERROR LED of the module will lit up.
Based on this error can occur two options:
Mute
-
When it fails there is not output signal.
PRBS
-
When it fails it modulates a pseudorandom signal.

Other Options:

4.4
- Firmware Version:
Shows the Firmware version of the module.
- Save:
Saves all changes made and validate.
Press ENTER
WARNING!
If you do not save the changes made, you will lose them after
turning off the control module!
Page 12
QUICK CONFIGURATION GUIDE. DT-202
to CONFIRM you want to save the changes.
11/2011