Promax DT-202 Guide Rapide page 15

QUICK CONFIGURATION GUIDE. DT-202
QUICK CONFIGURATION GUIDE
1 INTRODUCTION
The module DT-202 is able to receive two DVB-S signals, from
which extracts the sequence of digital data (Transport Stream) and then
modulates them again, combining them in a single DVB-T signal, in order to
distribute it in UHF band (for the "V" option it is distributed in the band from
170 MHz to 650 MHz).
The output signal has better quality, allowing its way through multiple
amplifier stages, drifters, long cables, etc.
Among the practical applications of this module are the possibility to
choose what DVB-S free channels will become DVB-T, the restoration of the
quality of a weak signal or the possibility to move DVB-T channels from one
frequency to other, to avoid degradation of the signal or overlapping on
other channels.
After going through this process, the signal of the DVB-T module can
be inserted into a television distribution network, with the advantages of
robustness and high quality offered by the digital technology.
At the bottom, the main screen shows the DVB-T Status, the bitrate
used in kilobit per second and the percentage of bitrate used relative to the
total available.
The DT-202 module adjusts the compression rate to the total bitrate
available, using the modulation parameters.
11/2011
DT-202
SELECT MODULE DIGITAL TO TV
DT-202-S1-M1
PASSWORD
DVB-T OK EDIT PASSWORD AND PRESS ENTER BR: 801 Kb/S (4%)
Figure 1.- DT-202 Configuration.
2/3
Page 1