Starting The Engine - Dolmar PC-6412 Manuel D'instructions Et De Sécurité

DOLMAR HP 100 high-performance two-stroke engine oil
is available in the following sizes to suit your individual
requirements:
0,5 l Best.-Nr. 980 008 109
DOLMAR high-performance two-stroke engine oil (50:1) is
available in the following sizes to suit your individual
requirements:
1 l Best.-Nr. 980 008 107
100 ml Best.-Nr. 980 008 106
NOTE: For preparing the fuel-oil mixture first mix the entire
oil quantity with half of the fuel required, then add the
remaining fuel. Shake the finished mixture thoroughly
before pouring it into the Power Cut tank.
Caution: Open the tank cap carefully, as pressure might
have built up inside!
It is not wise to add more engine oil than specified to
ensure safe operation. This will only result in a higher
production of combustion residues which will pollute
the environment and clog the exhaust channel in the
A
STOP
B
C
14
Fuel mixture
1
cylinder as well as the muffler. In addition, fuel con-
sumption will rise and performance will decrease.
Fuel storage
Fuels have only a limited shelf-life. Buy only as much as
you will use in 4 weeks.
Store fuel only in approved and marked containers.
AVOID SKIN AND EYE CONTACT
Mineral oil products degrease your skin. If your skin comes in
contact with these substances repeatedly and for an ex-
tended period of time, it will dry out. Various skin deseases
may result. In addition, allergic reactions are known to occur.
Eyes can be irritated by contact with oil. If oil comes into your
eyes, immediately wash them with clear water.
If your eyes are still irritated, see a doctor immediately!
Refuelling
IMPORTANT:
FOLLOW THE SAFETY PRECAUTIONS!
Be careful and cautious when handling fuels.
The engine must be turned off and cooled down!
Carefully clean the area around the fuel-tank filler neck to
keep dirt from getting in the tank.
Place the unit on its side on an even surface.
Unscrew the tank cap and fill tank with fuel mixture. Take care
to avoid spilling.
Tightly screw on the cap.
Clean screw cap and tank after refuelling. Never start or
operate the Power Cut in the same place as it was fuelled!

Starting the engine

This model features a semiautomatic starting valve (1) (Happy-
Start) to make starting easier. Pushing this valve in reduces
the amount of compression effort needed, so that it is easier to
bring the engine up to starting speed when pulling the starter
cable.
The high pressure increase in the combustion chamber that
results from the first ignitions will automatically close the starting
valve (button pops back out).
if
necessary