TOUCH&STEAM OPERATING AND MAINTENANCE MANUAL
7.
CLEANING AND MAINTENANCE
Before performing any cleaning and/or maintenance operations the
unit must be disconnected from the power supply and the water inlet
tap must be turned off.
CLEANING
The front panel of the generator is made of toughened glass and therefore during cleaning all the precautions
necessary for glass must be taken.
Clean the column with a soft cloth, using water and possibly a neutral detergent, particularly on the varnished
border to the side.
Do not use sharp or abrasive tools that may cut or scratch the seals and the varnished surfaces.
BOILER CLEANING
The steam generator performs a regular internal boiler cleaning procedure that lasts about 4-10 minutes.
This procedure is only signalled when the Hammam/Turkish bath is operating, when the temperature setting
button flashes.
The picture below shows an example at medium temperature.
7.1
ROUTINE MAINTENANCE
Maintenance must only be performed by qualified personnel.
Before gaining access to any of the internal parts, disconnect from the electricity and water
mains. In all circumstances, maintenance must be performed in compliance with the safety
regulations that apply to the installation site.
The data and features referred to are not binding on EFFEGIBI and the company reserves the right to make any appropriate changes
Boiler cleaning signal
without having to give prior warning or replace this manual.
EN
21