Troubleshooting - RIDGID 300Compact Mode D'emploi

Troubleshooting

PROBLEM
Torn threads.
Out-of-round or crushed
threads.
Thin threads.
No cutting oil flow.
Machine will not run.
Pipe slips in jaws.
POSSIBLE REASONS
Damaged, chipped or worn out dies.
Incorrect cutting oil.
Insufficient cutting oil.
Dirty or contaminated oil.
Die head not properly aligned with pipe.
Improper pipe.
Die head not properly set.
Carriage not moving freely on rails.
Die head set undersize.
Pipe wall thickness too thin.
Dies inserted into head in wrong order.
Forcing carriage feed handle during threading.
Die head cover plate screws are loose.
Low or no cutting oil.
Machine set up for Left Hand Threading.
Oil Screen Plugged.
Oil flow rate not properly set.
Die head not in the threading (DOWN) position.
Motor brushes worn out.
Jaw inserts loaded with debris.
Jaws inserts worn out.
Pipe not properly centered in jaw inserts.
Chuck not tight on pipe.
300 Compact/1233 Threading Machines
Replace dies.
Only use RIDGID
Check oil flow rate and adjust as needed.
Replace the RIDGID
Clean chips, dirt or other foreign material from
between die head and carriage.
Recommend using with black or galvanized steel
pipe.
Pipe wall too thin – use schedule 40 or heavier
pipe.
Adjust die head to give proper size thread.
Clean and lubricate carriage rails.
Adjust die head to give proper size thread.
Use schedule 40 or heavier pipe.
Put dies in proper position in die head.
Once dies have started thread, do not force car-
riage feed handle. Allow carriage to self-feed.
Tighten screws.
Fill oil reservoir.
Reverse the oil pump hoses (see section on Left
Hand Threading).
Clean Screen.
Adjust oil flow rate.
Move die head to the threading position.
Replace brushes.
Clean jaw inserts with wire brush.
Replace jaw inserts.
Make sure pipe is centered in jaw inserts, use the
rear centering device.
Use repeated and forceful counterclockwise spins of
the handwheel to secure the pipe in front chuck.
SOLUTION
® Thread Cutting Oil.
Thread Cutting Oil.
®
19