Alarm Setting - LEXIBOOK MeteoClock Evolution Compact SM180 Mode D'emploi

1. In time display mode, press the "MODE/SET" key twice to go the alarm setting.
The icon is displayed on the LCD screen when the unit is in alarm mode.
2. To set the alarm time, press and hold the "MODE/SET" key until the weather
station makes a "beep" sound and the hour's digits start flashing.
3. Use the "+ (12/24)" and "- (°C/°F)" keys to adjust the hour, then press "MODE/
SET" to confirm and adjust the minutes.
4. Use the "+ (12/24)" and "- (°C/°F)" keys to adjust the minutes, then press
MODE/SET to confirm and go to the next setting.
5. Use the "ALARM" key to switch on or switch off the alarm. The
displayed on the LCD screen when the alarm is switched on.
6. When the alarm rings, press the "SNOOZE/LIGHT" key to switch on the snooze
function. The icon starts blinking and the alarm will ring again 7 minutes
later. Press any other key than the "SNOOZE/LIGHT" key to stop it. The alarm
will ring again the next day at the same time. If you wish to deactivate the alarm
completely, in time display mode, press the "ALARM" key. When the
disappears from the LCD screen, the alarm is switched off.
Note: In "alarm" mode or during the settings, if you don't press any key, the unit
goes automatically back to the time display mode.
TEMPERATURE DISPLAY IN CELSIUS/FAHRENHEIT
In time display mode, press the "- (°C/°F)" key to toggle between temperature
display in Celsius (°C) or Fahrenheit (°F).
Press the MODE/SET key to confirm your selection and go to the clock setting.
Note: If the temperature is out of the measurable range, "LL.L" (below the
minimum measurable temperature) or "HH.H" (beyond the maximum measurable
temperature) will be shown on the LCD screen.
Copyright © Lexibook 2009

ALARM SETTING

icon is
icon
17