Stiga SNOW KICK Manuel D'assemblage page 7

wARninG! conTAinS SMAll PARTS.
choKinG hAZARd
CaUtION!
• Read the manual carefully before using your new product.
• This product should always be assembled by an adult.
• Before each ride, make sure that all screws are tightened and that the levers / connections are
in their proper positions.
• We recommend that you wear a helmet when using the product.
• Be careful when riding this product in order to avoid falls or collisions which can injure the
user or other people.
• This product is only intended for use on level ground. Do not ride in downhill slopes.
• Do not use the product for tricks or jumps.
• Must not be used in traffic.
• Do not let children use the product without adult supervision.
• All use of the product is at one's own risk.
• The instructions should be saved in case it becomes necessary to lodge a complaint with
regard to the product.
aSSEMBLY
See pictures on page 2
• Release the quick release collar (fig A1).
• Pull the release lever (fig A2) and fold out the front fork into an upright position.
• Lower the release lever (fig B1) and tighten the screw (figure B2) and the quick release collar
(fig C1) properly.
• Attach the skis in the intended position. Tighten the screws with the hex key so that they are
firmly in position. Use the shorter screw for the front ski and the longer screw for the rear ski.
(fig D1)
• Attach the handlebar to the steering column and make sure the spring button (fig E1) is in the
locked position.
• Adjust the handlebars to a suitable height for you (make sure that the spring button (fig F1) is
in the locked position) and then tighten the quick release collar (fig F2) properly.
ENGLISh
STIGA Snow Kick - Art.nr. 75-1118-XX
Adjustable height 77-87 cm
5+
Max user weight
7
50 KG
GB