Making A Telephone Call; Making An 2-Way/ Intercom Call; Handset To Handset Calls; Intercom/2-Way From Base To Handset - EnGenius EP801 Manuel D'utilisation

Making a Telephone Call

A. From Handset
1. Press
, wait for dial tone, and then enter phone
number.
2. Alternatively, you can enter phone number first then
press key.
When using this method, you can use the
(Left) and DELETE (Right) soft keys to edit the number
entered. "Delete" erases the last digit entered. "Clear"
erases the entire line but remains in the dialing mode.
3. Speed dial by access the entries in the phone book
(Menu 2)
a. Press or scrolling key to enter the phone
book
b. Press
to dial out the number
4. To abort dialing, press
key.
Notes:
1.
If the line is occupied, the LCD shows "No Line Available"
and handset returns to standby mode.
2.
If a link cannot be established, the LCD will show "No Base"
after a 12-second time out.
3.
A call duration timer will start displaying the length of the call
after link is established.
B. From Base
1. Press
, wait for dial tone, and then enter phone number.
2. Speed dial by access the entries in the base memory.
Press and the location of speed dial "N" (N：00~19), then press
CLEAR
~27~
3. Press
again to hang up the call.

Making an 2-Way/ Intercom Call

The EP801 Cordless Phone System offers private, Intercom/ 2-way radio
calls independence of base station. Intercom/ 2-way communication can be
placed from or to base stations and handsets.
A. Handset to Handset Calls
1. Press
key followed by a two-digit handset ID or
Group ID.
2. Press key to end the call.
Notes:
1. Intercom calls can be made regardless if the Base Station is
present.
2. If a Group ID is entered, the first handset (belonging to that
group) that answers will establish a link with the caller. See
Handset Group Subscription.
3. If a link cannot be established, the LCD shows "No
Connection" after a 12-second time out.
B. Intercom/2-Way from Base to Handset
1. Rapidly press
key twice on the base station to intercom all
registered handsets. The first handset to answer will establish a voice
link with the base.
2. Press
key on the base station and wait for 2 seconds to intercom
all registered handsets. The first handset to answer will establish a
voice link with the base.
3. Either press
key followed by a two-digit handset ID/group ID, or
press a two-digit handset ID/group ID followed by
intercom the designated handset/ group.
4. The INTERCOM LED will flash until a handset responds.
key to
~28~