Message List - Alpine KTX-100EQ Mode D'emploi

Message List

Message ID
Error Code: E001
Error Code: E002
Error Code: E003
Error Code: E004
Error Code: E005
Error Code: E006
Error Code: E007
Error Code: E008
Error Code: E009
Error Code: E010
Error Code: E011
Error Code: E012
Error Code: E013
Error Code: E014
Error Code: E015
Error Code: E016
Error Code: -1
Error Code: -2
Error Code: -3
Error Code: -4
Error Code: -5
Error Msg: M001
Error Msg: M002
"MultEQ Error: The channel has been marked as undetected, and will be
skipped."
"MultEQ Error: The bass management configuration selected is not
supported by the device. Please consult the manufacturer's manual to
determine a valid configuration."
"MultEQ Error: The speaker configuration specified is not valid. Please
consult the manufacturer's manual to determine a valid configuration."
"MultEQ Error: Communication with the device failed. Please check the
connection and try again."
"MultEQ Error: The device is not properly licensed."
"MultEQ Error: Device in use, try again in a few moments."
"MultEQ Error: The Maximum level was reached, without achieving an
adequate signal. Please decrease the ambient noise and try again."
"MultEQ Error: The hardware sample format or bit depth is not supported."
"MultEQ Error: The action was cancelled by the user."
"MultEQ Error: The system was unable to calculate a filter for this response.
Please try your measurements again. If this problem persists, contact
technical support."
"MultEQ Error: The system was unable to determine the delay (speaker to
microphone distance). Measure this value manually."
"MultEQ Error: The system may have been unable to determine the delay
(speaker distance). Numbers given for this value should be checked
manually."
"MultEQ Error: The input signal is too low. Check that the microphone is
connected to the selected input, and check that the gain on the preamp or
audio hardware input channel is properly set."
"MultEQ Error: The measured signal was too low, even though output was
raised to the maximum available amplitude. Decrease ambient noise, and
start over."
"MultEQ Error: The measured background noise exceeded allowable
tolerances."
"MultEQ Error: An unspecified error has occurred."
MEASURE CANCEL
MEASURE COMMAND ERROR
FL SPERKER NO DETECT
H.U NOISE MEASURE START ERROR
H.U MEASURE START ERROR
"The MultEQ Pro appliation failed to communicate with the device. Please
check the ALPINE Device configuration and try again."
"The device is not properly licensed."
Error Message
7
-EN