Inserting The Batteries Into The Remote; Connect Power; Important Safety Information; Antenna Connection - Durabase L24H472S4V Mode D'emploi

Important safety information

Changing Channels and Volume
You can change the channel and adjust the volume
by using the Volume +/- and Programme +/- buttons
on the remote.

Inserting the Batteries into the Remote

Remove the screw that secure the battery compartment
the cover gently. Insert two size AAA batteries. Make
sure the (+) and (-) signs match (observe correct
polarity). Do not mix old and new batteries. Replace
only with same or equivalent type. Place the cover back
on. Then screw the cover back on again.

Connect Power

IMPORTANT: The TV set is designed to operate on 12
V DC. For this, an adaptor is used which gives 12 V
voltage. Connect this adaptor to a system that supplies
110-240V AC, 50/60Hz.
Be sure to ground the connection
properly
Connect the ground terminal of the AC
adaptor with the ground terminal provided at
the power outlet using the enclosed power
outlet, consult an electrician for replacement
of the obsolete outlet.
Surely connect the ground wire.
To POWER INPUT
DC 12 V terminal
AC adaptor
cover on the back side of the remote control first. Lift
cord. If the provided plug does not fit your
REAR
OF
THE TV
satellite
aerial
or
cable

Antenna Connection

Connect the aerial or cable TV plug to the AERIAL
INPUT (ANT) socket or satellite plug to the SATELLITE
INPUT (LNB) socket located on the back of the TV.
TRADEMARK ACKNOWLEDGMENT
The terms HDMI and High-Definition Multimedia
Interface, and the HDMI Logo are trademarks or
registered trademarks of HDMI Licensing Administrator,
Inc. in the United States and other countries.
Manufactured under license from Dolby Laboratories.
Dolby, Dolby Audio and the double-D symbol are
trademarks of Dolby Laboratories.
Information for Users on Disposal of Old Equipment
and Batteries
[European Union only]
Equipment bearing these symbols should not be
disposed as general household waste.
You should look for appropriate recycling facilities and
systems for the disposal of these products.
English - 29 -
Notice: The sign Pb below the symbol for batteries indicates
that this battery contains lead.
Battery
Products
TV Broadcasting PAL B/G D/K K I/I'
VHF (BAND I/III) - UHF
Receiving Channels
(BAND U) - HYPERBAND
Fully integrated digital
terrestrial-cable-satellite
Digital Reception TV(DVB-T-C-S)
(DVB-T2, DVB-S2
compliant)
Number of Preset
10 000
Channels
Channel Indicator On Screen Display
RF Aerial Input 75 Ohm (unbalanced)
Operating Voltage 110-240V AC, 50 Hz.
Audio German+Nicam Stereo
Audio Output Power
2 x 2,5 W
(WRMS.) (10% THD)
Power Consumption (W) 47 W
TV Dimensions DxLxH
135 x 554 x 370 mm
(with foot) (mm)
TV Dimensions DxLxH
35/61 x 554 x 336 mm
(without foot) (mm)
Display 24"
Operation temperature 0ºC up to 40ºC, 85%
and operation humidity humidity max
English - 30 -