Unloading The Dishwasher - ETNA AFI8525ZT Notice D'utilisation

3. Press the On/Off button. The dishwasher
must be in setting mode.
4. Press the programme selection/cancel
button until the light corresponding to the
required washing programme comes on
(see "Washing programmes" chart).
Close the dishwasher door, the pro-
gramme starts automatically.
Setting and starting the programme with
delay start
The start of the washing programme will
be delayed by 3 hours.
1. Select a washing programme.
2. Press the delay start button. The corre-
sponding indicator light comes on.
3. Close the dishwasher door. The count-
down starts automatically.
Opening the door will interrupt the
countdown. Once the door is closed the
countdown will continue from the point
at which it was interrupted.
4. Once the countdown has elapsed the
washing programme will start automati-
cally.
Cancel a delay start in progress
1. Open the dishwasher door.
2. Press the delay start button. The corre-
sponding indicator light goes off.
3. Close the dishwasher door. The washing
programme will start automatically.
Warning! Interrupt or cancel a
washing programme in progress
ONLY if it's absolutely necessary.
Attention! Hot steam may escape
when the door is opened. Open the
door carefully.

Unloading the dishwasher

• Hot dishes are sensitive to knocks. The
dishes should therefore be allowed to cool
down before removing from the appliance.
• Empty the lower basket first and then the
upper one; this will avoid water dripping
from the upper basket onto the dishes in
the lower one.
• Water may appear on the sides and the
door of the dishwasher as the stainless
Interrupt a washing programme in
progress
Open the dishwasher door; the programme
will stop. Close the door; the programme will
start from the point at which it was interrup-
ted.
Cancel a washing programme in
progress
• Open the dishwasher door; press the pro-
gramme selection/cancel button for about
3 seconds, until the light of the running
programme goes off and the End indicator
light flashes. The washing programme has
been cancelled and the appliance is now
in setting mode. .
• If a new washing programme is to be se-
lected, check that there is detergent in the
detergent dispenser.
End of the washing programme
• The dishwasher will automatically stop and
an audible signal informs you of the end of
the washing programme.
• Open the dishwasher door.
• The End of programme indicator light is
on.
• The indicator light of the programme just
ended remains on.
1. Switch off the dishwasher by pressing the
On/Off button.
2. Leave the dishwasher door ajar and wait
a few minutes before removing the
dishes; in this way they will be cooler and
the drying will be improved.
steel will eventually become cooler than
the dishes.
When the washing programme has
finished, it is recommended that the
dishwasher is unplugged and the
water tap turned off.
33