Electrolux A11199803 Instructions D'installation page 20

20 Reversing Door
Removing Door Assembly
1. Completely open the door to expose all
four hinge screws.
2. Remove all four hinge screws with #2
square bit driver. Save for reinstalling
later.
x4
3. Grasp the door with both hands and
lift slightly as you pull door and hinge
away from the front panel.
Reinstalling Door Assembly
1. Rotate the door and hang the upper
hook on the back of the hinge in the
upper hole of the front panel.
2. Reinstall and tighten all four screws
removed earlier - two front screws first,
then two side screws.
1
3
4
2
Reinstalling Latch and Hole Plugs
1. Install door latch with screws removed
earlier.
2. Insert plastic hole plugs removed
earlier.
x2
Verify Reversed Door Operation
1. Test door for free, smooth swinging
operation and secure latching when
closed.
2. Plug in dryer and close the door. Start
a test cycle: drum should tumble until
door is pulled open or cycle is paused
or canceled.
x4
x2