Placing; Electric Connection - Airpress EURO Série Manuel D'instructions

 Make sure that the machine and the cable never come in contact with water.
 Treat the power cable with care. Do not attempt to move the machine by pulling the
cable. Do not yank the cable to unplug it; keep the cable away from excessive heat,
oil and sharp objects.
 Never leave the machine unattended with the power supply "on". Also
disconnect the power cable when:
- you leave the machine, even for a short time
- not in use
- carrying out maintenance work
- changing attachment or moving the machine.
 WARNING: the warnings, cautions and instructions discussed in this instruction
manual cannot cover all possible conditions and situations that may occur. It
must be understood by the operator that common sense and caution are factors
which cannot be built into this product, but must be supplied by the operator.
 Only those persons who are aware of how to use the compressor by having read
this manual, should use the machine. Injudicious use may cause danger.
Danger plates (see page 28/29)
The plates fitted on the compressor unit are part of the machine; they have been
applied for safety purposes and must not be removed or spoiled for any reason.

3.0 PLACING

The compressor should be placed in such way that all points, destined to carry it will
really do so. Take also care of a horizontal position. The engine should get sufficient
cooling air; so never cover the ventilating openings.
Place the compressor in a cool dust free space. Never place the compressor in a
room where will be sprayed. Paint spray will clog the air filter and will also deposit on
the compressor.
Mind that the drain tap for condensation water (K) will always remain attainable. We
suggest to leave a space of approximately 30 cm for ventilation and maintenance.
Notice: Insufficient air supply, too high temperature and fouling of the air filter
reduce the efficiency of the compressor considerably.

3.1 ELECTRIC CONNECTION

At the factory the machine is already fully equipped with cables. The machine now has
to be connected to your own electricity supply. Connect the machine to a separate
group. Beware that voltage and amperage of your electric circuit meet the needs of the
motor. Use only cables with the right diameter. The factory suggests to use cables of
at least 2.5 qmm.
Before first use first read chapters 3.2 and 4.0.
16