Installation And Operation - THORENS MM FLEX Mode D'emploi

Installation and Operation

Assembly
Identify a space on your turntable where you wish to fit
the MM Flex and make sure it is dry and free from grease,
dirt, dust and fingerprints. This should not be close to the
motor or any other source of magnetic field. Peel off the
protective film on the Velcro™ strip on the rear of the MM
Flex, then, taking care not to touch the adhesive, fix the
entire unit to the turntable in the desired position and
apply pressure for 20-30 seconds.
Connection and Operation
Please read the following instructions carefully and carry
them out in the order shown.
1. Connect your turntable to the MM Flex
Plug the leads from your turntable's cartridge to the input
sockets on the MM Flex; the Right channel (red) cable
into the Right input and the Left channel (white) into the
Left input. If your tonearm has a separate earth wire for
shielding purposes, please connect it to the earth
binding post on the MM Flex.
Your amplifier should be powered off or muted and
The MM Flex's power supply should not yet be
connected.
8
2. Connect the MM Flex to your amplifier
Connect good quality RCA interconnect cables from
the MM Flex to an auxiliary line-level input on your
amplifier (Aux, Tape in, CD, Tuner, etc,).
Please ensure that the right channel output is connected
to the right channel input on your amplifier, and the left
channel output is connected to the left channel input on
your amplifier.
If your amplifier is already equipped with a phono
stage, do not connect the output of the MM Flex to the
phono input: this is meant to be connected only to a
turntable's cartridge output, not to a line level output
such as that of the MM Flex.
-