Storch AirClean 4200 PRO Notice D'emploi page 28

You can read off the elapsed operating hours from the operating hours
counter.
Use for drying buildings
When drying builds deploy at least one extraction fan per
room. Make sure that the outlet side faces the wet surfa-
ces.
Use of the extraction fan increases evaporation in the room.
This increases the humidity and drying becomes slower.
For this reason, we recommend additionally deploying a
building dryer (air dehumidifier), e. g. the STORCH High-
Dry 650 Building Dryer. (Art. No. 61 55 00). To accelerate
drying, seal off the area to be dried from the rest of the
building. For best possible dehumidifying performance, the
ambient temperature should be between 20° C and 27° C.
Troubleshooting
Warnung:
Make sure you have unplugged the mains plug before per-
forming the following maintenance tasks.
Error Cause
Motor not running Mains plug not plugged in
Switch not actuated
Fan wheel blocked
Air inlet or outlet blocked
Switch defective
Loose wiring
Motor running, fan A heavy blow has deformed the
wheel not turning motor mounting, the fan wheel is
smoothly or scraping jammed
The motor has slipped out of its
mounting, the fan wheel is jammed
Device vibrating Dirt on fan wheel
excessively
Fan wheel imbalanced
Fan wheel deformed
Motor shaft deformed
Translation of the original instruction
Operation
Always use an earthed power supply at 230 V / 50Hz to
operate the extraction fan. If you will be using the extrac-
tion fan for extracting and filtering dust and spray mist,
make sure you use the clamp to attach the dust bag in-
cluded with the device to the extraction side (direction of
arrow). Switch on the device and check that it is operating
properly. Do not move or transport the extraction fan du-
ring operations. Do not reach into, or insert objects into,
the device.
Service/Maintenance
Caution:
Always unplug the power plug before commencing servi-
cing or maintenance work.
Visual check: Check the power cable, housing, ventilator
covers and motor housing regularly for signs of damage.
Clean the air intake: Clean the air intake: Remove any so-
iling that has built up at the air intake. Use compressed air
to remove fibrous material, dust and fan blades from the
fan wheel, motor and side covers. Never clean the extrac-
tion fan with a water jet or a pressure washer.
Motor bearings: The bearings on the device are perma-
nently lubricated. Do not oil or grease.
Column 3:
B - User, AST - authorised service centre
by Solution
B Plug in device, check fuse
B Switch on device
B Pull mains plug, remove block
B Switch off, unplug and allow to cool;
then remove block
AST Fit a new switch
AST Check wiring and tighten connectors
AST Remove motor, repair deformed
motor mounting replace if necessary
AST Refit motor, fitting it correctly in the
mounting
B Clean fan wheel
AST Balance or replace fan wheel
AST Replace fan wheel
AST Replace motor
28