Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
TO CHARGE THE BUILT-IN BATTERY:
You may charge the built-in battery (Lithium 500mAH) using a USB cable
and a USB LPS power adaptor, computer or mobile LPS charger (not
included). While charging, make sure to keep the BC-100 and USB cable
out of reach of children.
It takes approx. 1.5 hours to fully charge the battery (depending on the
used adaptor).
The USB port is only suitable for charging the BC-100. While charging, the
red LED indicator will remain lit. The LED indicator turns to green as soon
as the battery is fully charged. The
icon appears in the display when
the battery starts running empty and later the LED lighting will stop. In this
case, please charge the battery. When using the product in a fixed place,
it's advisable to use an adaptor continuously.
DISPLAY SETUP:
The day and night time are already set in the factory.
The day time
starts at 6am.
The night time
starts at 6pm.
Use the
button to switch between the day time display ( ), night
time display (
) and actual time ( ).
CLOCK SETUP:
Make sure to activate the "clock ( )" display.
Press and hold the
button for 2 seconds until the hour display starts
flashing. Use the "+" and "-" buttons to set the correct hour. Press the
button to continue to the minute setting, the minute display starts flashing.
Use the "+" and "-" buttons to set the correct minutes. Press the
button
to confirm your input.
Hour "+,-"
Min "+,-"
2
sec.
display
- 19 -
Publicité
Table des Matières
