Receiver Decoding; Auxiliary Lines - Videotec SM328A Manuel D'instructions

8.3.4

Receiver decoding

If you wish to decode the receivers, click on the CheckBox called "Receiver decoding". The box "Receiver
assignment" appears where, next to each camera, there is a field with an UpDown in which to input the
receiver's ID number (see figure 13).
Click to bring up
the "Receiver
Assignment" box
Click on the "Use Auxiliary
Lines" CheckBox to
configure the auxiliary lines
figure 13: receiver encoding, auxiliary lines
8.3.5

Auxiliary lines

To configure the auxiliary lines auxa and auxB click on the CheckBox called "Use aux lines". The two
auxiliary line configuration boxes appear.
For each auxiliary line, select the protocol by clicking on the arrow of the "Protocol" ComboBox.
Select the baud rate by clicking on the arrow of the ComboBox called "Baud". The "Baud" ComboBox
cannot be seen unless a protocol has been set.
Refer to figure 14.
Click on the "<< Back" button to return to the previous screen.
Click on the ">> Next" button to continue.
•
8. Configuration software
Protocol selection
ComboBox
Page 53/66
UpDown field in which to input
the ID number of the receiver
corresponding to camera 9
Baudrate selection
ComboBox
The "Baud" ComboBox
does not appear due to
the fact no protocol has
been set
MNVCSM328A_1511_EN